Maverick Den STEM Robotics Pvt. Ltd.
Email: info@maverickden.com
Contact No. : 7715916683 (India)
60123250147 (Malaysia)

Start Your Career with STEM Based Robotics (In 6/12 Weeks Internship) , Launching Innovation Lab in JVM's Mehta Degree College, Airoli, Navi Mumbai.

PCB Design

Initially PCBs were designed manually by creating a photomask on a clear mylar sheet, usually at two or four times the true size. Starting from the schematic diagram the component pin pads were laid out on the mylar and then traces were routed to connect the pads. Rub-on dry transfers of common component footprints increased efficiency. Traces were made with self-adhesive tape. Pre-printed non-reproducing grids on the mylar assisted in layout. The finished photomask was photolithographically reproduced onto a photoresist coating on the blank copper-clad boards.

Printed circuit boards (PCBs) have long been the foundation of electrical engineering, serving as the “brains” of any powered device. Designing PCBs is to electrical engineering as HTML is to web development—the backbone that makes it all possible. That’s because no powered device works without a PCB of some sort. From cell phones and remote controls to robotics and toys, PCBs provide electricity and connectivity between the components of a device, allowing it to function the way it was designed.

Overview

A basic PCB consists of a flat sheet of insulating material and a layer of copper foil, laminated to the substrate. Chemical etching divides the copper into separate conducting lines called tracks or circuit traces, pads for connections, vias to pass connections between layers of copper, and features such as solid conductive areas for EM shielding or other purposes. The tracks function as wires fixed in place, and are insulated from each other by air and the board substrate material. The surface of a PCB may have a coating that protects the copper from corrosion and reduces the chances of solder shorts between traces or undesired electrical contact with stray bare wires. For its function in helping to prevent solder shorts, the coating is called solder resist.